UK Soundproofing

The Regulation E Specialists

Sales - 020 8123 4722

Fitting - 07943 833022

The shopping basket is empty

Isosonic Timber floor

The ISOSONIC TIMBERFLOOR provides safeguards against failure with 'pre completion testing'.

Ceiling Solution 1- Isosonic Type C hangers System.

 

Calculate your materials requirement by clicking here

  • Site tested performance far in excess of test requirements
  • 1 hour fire proof
  • Simple installation reducing workmanship errors
  • Integral flanking sound insulation, eliminating difficult edge strips
  • Detailed installation for floor, ceiling, down lighters and partitions- aiding the builder and specifier
SITE TEST PERFORMANCE COMPARABLE TO R.D. STANDARDS
  • A high performance, low cost and simple to install system.
  • Provides a unique integral barrier to flanking sound transmission which is the predominant cause of test failures.
  • ISORUBBER BASE is suitable for the direct application of timber and laminate floors without a board platform.

Below shows a detailed set up of isosonic rubber mat and hangers in place. We would recommend keeping the existing ceiling in place if you can.

Other possible hanger options

Ceiling Hanger type A
For minimal loss in ceiling height
5mm lowering of ceiling
Ceiling Hanger type B
For adjustable ceiling height
Hangers can be made to suit the exact ceiling level requirements
Ceiling Hanger type C
For retained ceilings
Allows the new sound insulating fire protective ceiling to be installed without the removal of the existing ceiling

Calculate your materials requirement by clicking here

Isosonic Ceiling Hangers

a) The number of ceiling hangers required per square metre of floor will depend on the geometry of the room. Regular rectangular rooms require approximately 2.5 hangers per square metre of floor area.

b) Spacing of the ceiling hangers should not exceed 800mm.

PACKAGING

6mm Isorubber Base Rolls: 1.0m x 10m = 10m2
Weight per roll: 36kg
Isosonic Ceiling Hangers Boxes: 100 pieces per box.

SOUND INSULATION PERFORMANCE DATA

 
Dntw + Ctr
Airbourne Sound
Lntw
Impact Sound
Regulation New build
45 dB minimum
62 dB maximum
Regulations Refurbishment
43 dB minimum
64db maximium
Type C Hangers ( Average 30 tests)
50 dB minimum
57 dB maximum
Any one single test
47 dB minimum
60 dB maximum
18mm Chipboard over Isorubber Base
50
56
Laminate floor over 18mm chipboard over Isorubber Base
51
54

N.B. The Isosonic Timber Floor is not an official R.D. but has been tested to similar standards.

© Sound Solution Ltd